Introduction To Solar Street Light Installation Construction Specifications And Their Precautions

After the user purchases the solar street light, it is still necessary for the equipment, and the general engineering solar street light equipment is still required. In addition, solar street lamp top solar panels and lighting equipment, the determination of the equipment is still considered, because if the equipment is unstable, there is a simpler problem. Here, Xiaobian gave us the equipment specifications of the solar street light, and some paying attention. The first is to perform a lamp positioning and determine the orientation of the lamp. In addition to seeing the softness of the ground soil, the solar street lamp is located, and if there is a pipeline in the underground, it is necessary to consider whether there is an object that occluded in the sun. If any, it must be positioned from the head.

The sun lanterns, followed by excavation of pouring pits, and the general standard requirement is 1 meter 3 pit. Then put a layer of cement stone in the pit, then the embedded part, the ground cage is placed on the top of the above, and the pipeline and battery pits (if it is lithium battery is loaded into the lamp body). Then use concrete backfillet, pay attention to the concrete, the demand is flushed on the ground, and the embedded part must be flushed and the appropriate length is exposed.

Finally, to be dried by cement (generally 3 days, the season and climatic conditions can be extended for 1-2 days), and the solar street light can be lifted, and the equipment is carried out. In general, it is the first equipment to make the solar panel after the light pole. About some low-power small solar street lights, you can also first install the solar panels, and then build it again. After paying attention to the solar panel equipment, it needs to be adjusted to the best angle and increase the solar light energy as much as possible.